Do not attach tape on any edges of the mat because the tape could get stuck on the feed rollers during operation.
Brother scan and cut mat not recognised.
The cutting pressure may be too strong.
Possible causes or results case1.
In the scan to cut data function you can change the contrast levels allowing you control over how much information you would like scanncut to process for your design.
Then direct cut mode will not recognize it.
A mat was not inserted straight into the machine.
Our low tack mat and standard mat are to be used with the direct cut function.
The mat was inserted so that the side with the material attached is facing down.
You helped us identify and fix the root cause.
As you i recently purchased a brother scanncut machine and while i love it there is one thing i do not love and that is the mat.
Press on the operation panel to feed out the mat and then insert the mat straight into the machine again.
After a few.
Live demonstration ii show you two new issues after using the new brother dx for about 3 weeks mats load at a kink crooked went online and read tha.
Replace the mat with a new one.
Problem 2 and three simple solutions.
Replace with a new one if the mat is not being recognized.
The scanner glass is dirty.
The mat was inserted so that the side with the material attached is facing down.
Mats for the cm models will not work on this machine.
The scanning mat can also be used with scan to cut data function.
Touch in the settings screen once to decrease the cut pressure and then.
A mat that cannot be recognized has been inserted.
The dotted marks on the part of the mat that is inserted are dirty.
The dotted marks on the part of the mat that is inserted are hidden by material that was attached.
You should use the scan to cut data function for images or designs that have a lot of detail or background.
Clean the dotted marks at the edge of the mat and their surrounding areas.
The mat s adhesive strength may have been decreased or the material is not secured properly.
At brother we work hard to provide customers with the highest quality items.
So we thank our customers who contacted us about the difficulties with scanncut dx mat feeding process.
Problem 2 there are deep cuts completely through the mat or cut through the mat.
Insert the mat so that the side with the material attached is facing up.
